DIY Studded Friendship Bracelets

 

We can’t get enough of the friendship bracelet trend that we’ve been seeing everywhere. But of course we couldn’t just rock a plain friendship bracelet without adding some DIY embellishment! So we whipped up two different studded friendship bracelets to add to your stack of arm candy. Check them out below.

 

 

1. Gather your supplies. All you need is a friendship bracelet and a pack of pyramid studs.

 

2. Starting at one end of the friendship bracelet, push the stud into the bracelet. Make sure the prongs go all the way through.

 

3. Flip the bracelet over and push down each of the prongs to hold the stud in place. You can use your fingers, but you may want to use something like a butter knife to push the sharp prongs down.

 

4. Continue to add studs to your bracelet until you reach the end. Now you’re all done!


 

1. Get your supplies. You need a friendship bracelet, glue, and white round nailheads.

 

2. Apply a small amount of glue to the back of one of the nailheads. You may want to use a toothpick to do this.

 

3. Gently place the nailhead near one end of the friendship bracelet. Hold in place for a few seconds while the glue dries.

 

4. Use the same technique to apply the rest of the nailheads to the bracelet.



 

 

 

 

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s